Magnum Dynalab Ltd.

Triode Series

Since the dawn of the radio. the purist form of amplification has been the Triode Tube design. Magnum Dynalab Ltd. utilizing the talents of a foremost tube designer, Zdenko Zivkovic, is proud to introduce their Triode Series of tuners. Their are two key areas of the design:

  • 1. Special attention has been paid to the ground plane to insure that the main signal is not infected by any stray ground path signals; this insures that the micro information of the passages is not lost.
  • 2. The design has zero feedback that maintains the integrity of the original waveform.

MD 90 Triode

Internal IR Remote System,  available option:  $250.00 USD


1,595.00 U.S.

MD 100 Triode

  • -In house designed four stage tuning front end
  • -Matched Philips military grade 6922 tube in the amplification stage
  • -Printed circuit board is .093 thick to minimize vibration
  • -Wire in the audio path is Kimber Hyper-Pure copper
  • -Torroidal Transformer
  • -Solen polypropylene caps with bypass caps

Internal IR Remote System,  available option:  $250.00 USD


2,195.00 U.S.
MD 102 Triode
  • -gold plated contacts on all conductive surfaces
  • -In house designed five stage tuning front end
  • -100 % RF isolation
  • -Certified Amperex Bugle Boy 6922 tubes in
    the amplification stage
  • -.093 thick printed circuit board to minimize vibration
  • -Wire in the audio path is Kimber Hyper-Pure copper
  • -Burr Brown op amps with Black Gate capacitors
  • -MIT caps in the audio path with MIT bypass
  • -MIT caps in the AC filtration
  • -Fully complimentary balanced design
  • -Hand matched filters to insure minimum distortion
  • -20,000 uf. Filtration

Internal IR Remote System,  available option:  $300.00 USD


3,195.00 U.S.
MD 106 Triode
  • -Utilizes a Magic Eye Tube for precise centre tuning
  • -In house designed five stage tuning front end
  • -100 % RF isolation
  • -Matched and certified Amperex “Bugle Boy” 6922 tubes
    in the amplification stage
  • -.093 thick printed circuit board to minimize vibration
  • -Wire in the audio path is Kimber hyper-pure copper
  • -Burr Brown op amps with Black Gate capacitors
  • -MIT caps in the audio path and MIT XS series in the bypass
  • -Fully complimentary Balanced Design
  • -Pearl Coolers on the tubes reduces the micro phonics and extends tube life

Internal IR Remote System,  available option:  $300.00 USD


3,995.00 U.S.


The PRECISION ANALOGUE REMOTE SYSTEM
Is now available as an option on all production Magnum Dynalab tuners, receivers and as an update to all previous Magnum Dynalab tuners and receivers.

This extremely accurate and silent remote system was developed in conjunction with engineering support from Texas Instruments and Archronix Corporation of Toronto, Ontario.

The remote utilizes TI’s latest 16-bit ultra low power processor with 60 KB flash memory, 2048 bytes RAM, 125-ns instruction cycle time, 12-Bit A/D converter with internal reference, Sample-and-Hold and auto-scan, Dual 12-Bit D/A converters, 16-Bit timer_A with three capture/compare registers, supply voltage supervisor/monitor and numerous additional features.

Needless to say this is the most accurate tuning system ever found in a Magnum Dynalab tuner as the resolution exceeds even that of our precision tuning potentiometers with no potential for performance degradation due to mechanical wear. The user can switch between manual and auto tune simply by turning the remote control off with the hand-held.

Future software upgrades to this system will include an auto alignment feature to compensate for deviations as components age or operating parameters change. Presets are maintained in a non-volatile flash memory in case of any power interruption.



Discontinued Products | Contact Us | Home | FAQ | All Current Products > | Photos